OkOb Web Forum - Print Page

Content-type: text/html OkOb Web Forum - Print Page


    
      
        OkOb Web Forum
        (https://www.okob.net/yabb/YaBB.cgi)
      

        3D Printing >> RepRap X2 Announcements >>  Marlin for X2 v1.0.0b2 firmware mod new features
        
(Message started by: Denis Bakin on Jul 15^th, 2012, 3:47am)

Title: Marlin for X2 v1.0.0b2 firmware mod new features
Post by Denis Bakin on Jul 15^th, 2012, 3:47am

New firmware changes. Added several new features (mostly for dual extrusion) and cleaned up the code a bit.

Here is the list of changes:
- rewrote M109 code to be less confusing;
- removed do_not_wait_if_lowering_temperature configuration var (just use m104 if lowering);
- changed the wait logic to consider any temperature within the TEMP_HYSTERESIS range to be acceptable to stop waiting;
- added W parameter to allow changing the time M109 waits for temperature stabilization after reaching the target range;
- added A parameter that if set to non 0 value will make the command wait for all the extruders that have non-0 target temperature;
- added L and H parameters (to M104 too) that allow to make the temperature lower or higher than the current target;
- added m208 command that takes parameters T,X,Y for configuring extruder offset on the fly (T - extruder number, X,Y offset from the imaginary printing point);
- made the extruder offset be a EEPROM storable/retrievable;

Commited to all branches.
GITHub link (branch "m"): https://github.com/dob71/Marlin/tree/m
Commit SHA1 ID: 8c6bea53e2415e1b5b8a3b6260ed1dae80557627